EasyManuals Logo

Intermec EasyCoder PX4i User Manual

Intermec EasyCoder PX4i
186 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
Chapter 3 — Starting Up
18 EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version)
Startup Files
When the printer is switched on, its behavior depends on the
existence of a startup file (autoexec.bat) in its memory. There are
two cases:
The printer is only fitted with the Intermec Shell
file-managing program, which allows the operator to choose
between a variety of applications and functions.
In addition to Intermec Shell, the printer is also fitted with a
custom made application program that is design to perform a
specific task, for example to print tickets, baggage tags, or
product labels for a certain company. Such a program may be
initiated by a startup file (autoexec.bat) stored in the printers
permanent memory or in a memory card.
There can be one startup file stored in each of three different
parts of the printer’s memory. If there are startup files stored in
more than one part, only one will be used with the following
priority:
1 An autoexec.bat file stored in a memory card, provided the
card was inserted in the printer before the power was switched
on.
2 An autoexec.bat file stored in the read/write part of the
printers permanent memory (device “/c”).
3 The pup.bat file (Intermec Shell) in the read-only part of the
printers permanent memory (device “/rom”).
Memory Card
If you want to use a memory card, you must insert it into the slot
in the printer’s rear plate before you switch on the power. The
memory card must be a CompactFlash card (8MB-1GB).
CompactFlash cards marked “CF+” will not work. You can use
the CompactFlash card to expand the printer’s storage memory
(“card1:”). There are also three types of pre-programmed
CompactFlash cards:
Note: If you insert a CompactFlash memory card that contains a
startup file before you switch on the printer, this startup file will
be used instead of Intermec Shell.

Table of Contents

Other manuals for Intermec EasyCoder PX4i

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermec EasyCoder PX4i and is the answer not in the manual?

Intermec EasyCoder PX4i Specifications

General IconGeneral
Print technologyDirect thermal
Maximum resolution300 x 300 DPI
DisplayLCD
Product colorSilver
Keyboard layoutNumeric
Standard interfacesRS-232, USB 2.0
Internal memory16 MB
Media thickness2.4/10 mm
Maximum label width120 mm
Maximum label length2.7 m
Maximum roll diameter213 mm
Supported network protocolsTCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements90 - 265 VAC, 45 - 65Hz
Power consumption (standby)20 W
Power consumption (printing)125 W
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)40 - 104 °F
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Depth482 mm
Width238 mm
Height275 mm
Weight12850 g

Related product manuals