Chapter 7 — Setup Mode
78 EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version)
Entering Setup Mode at Installation
The method of entering the Setup Mode depends on which
startup files are stored in the printer’s memory, a subject that was
more thoroughly discussed in “Startup Files” on page 18.
EasyCoder PX4i with Intermec Shell
1 Switch on the power.
2 When the display shows the message “Enter=Shell; x sec...”,
press Enter.
3 Press Setup (this facility can be used anywhere within
Intermec Shell).
4 Set up the printer as described in this chapter.
5 Return to Intermec Shell by pressing Setup.
EasyCoder PX4i with a custom-made application program
Normally, there is no need to enter the Setup Mode when using
application programs that start up automatically. Necessary
provisions for changing the setup, manually or automatically,
should be provided by the program.
To Next Page
Loading...
