Intermec EasyCoder PX4i User Manual

Chapter 10 — Troubleshooting
110 EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version)
Note 5: In the Direct Protocol, the user can enable error handling for specific errors using the
ERROR statement. When errors added to the built-in error handling occur, this event will be
set. The text included in the snmp trap is the standard text corresponding to the error.
Note 6: If an error occurs in the Fingerprint immediate mode, for example “out of paper” when
the print key is pressed, this event will be set.
Note 7: If an application is started but does not execute, the IRI will blink. This will occur for
example if there is a syntax error in the loaded program file. This is useful when a printer has an
AUTOEXEC.BAT file (startup file) that is supposed to run automatically.
Note 8: When execution is stopped with user break (SHIFT + PAUSE) or due to a run-time
error, the IRI shall be off. It will be set to on if the user changes mode to Direct Protocol or runs
an application. If, however, the application program handles the user break (ON BREAK) or
the runtime error (ON ERROR GOTO), the IRI will not be affected. In this case, it is up to the
application to set the status.
Note 9: At most, but not all, printer crashes, the console is reset. This will make the IRI go off.
Note 10: If the printhead temperature raises above 100°C, error 1088 occurs.
In Fingerprint, printing will be aborted. Resuming printing after the printhead has cooled off to
85°C must be handled by the application program.
In the Direct Protocol, the printing is paused but will be automatically resumed when the
printhead has cooled off to 85°C. Meanwhile, the printer is able to receive instructions and data
until the buffer is filled.

Intermec EasyCoder PX4i Specifications

General

Print technology	Direct thermal
Maximum resolution	300 x 300 DPI
Display	LCD
Product color	Silver
Keyboard layout	Numeric
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Media thickness	2.4/10 mm
Maximum label width	120 mm
Maximum label length	2.7 m
Maximum roll diameter	213 mm
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Power requirements	90 - 265 VAC, 45 - 65Hz
Power consumption (standby)	20 W
Power consumption (printing)	125 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	482 mm
Width	238 mm
Height	275 mm
Weight	12850 g