Appendix B — Media Specifications
EasyCoder PX4i Bar Code Label Printer User’s Guide (Fingerprint Version) 149
(d) Detection Slit Length
The length of the detection slit (excluding corner radii) must be a
minimum of 2.5 mm (0.10 in) to either side (right or left) of the
label stop sensor detection position.
(e) Detection Slit Height
Recommended: 1.6 mm (0.06 in)
Minimum: 1.27 mm (0.05 in)
Maximum: 25.0 mm (0.98 in)
Opacity
Max opacity difference: 48%
Media Type Setup: Gap Stock
Note: Handle perforated media carefully to avoid rips or breaks
along the perforations. Broken or ripped perforations, particularly
at the edges, may cause the media to break or misfeed during
printing.
a
b
e
d
c
To Next Page
Loading...
