Chapter 6 — Troubleshoot and Maintain the Scanner and Base Station
SG20B Scanner + Bluetooth Base Station User’s Guide 73
10 Click Start download.
The scanner disconnects from the base station and starts blinking
red. The base station status light blinks blue. This indicates they
are preparing for firmware download. When the download starts,
the scanner status light blinks slower red and the base station’s
status light stays on dimmed blue until the process is finished.
When finished, pull the trigger, the scanner emits a series of beeps
and the status light flashes green to indicate a successful
download. The base station and scanner restart.
You will need to re-establish a Bluetooth connection between the
scanner and the base.
Note: Some scanners may not blink red (older bootloader version)
however the firmware download does take place. Follow the
indications on the screen in WinFlash.
To Next Page
Loading...
