SECTION 8 " Programming
8-10 VT220/ANSI Terminal Emulation Programmer’s Reference Guide
Table 8-4 (Continued)
C1 Control Characters and Wireless Station Action
Mne-
monic Wireless Station ActionNameHex
SS3 8F Single shift 3 Temporarily invokes G3 character set into
GL for the next graphic character. G3 is
designated by a select character set (SCS)
sequence.
DCS 90 Device control string Processes as opening delimiter of a device
control string for device control use.
PU1 91 Private use 1 Ignores this code.
PU2 92 Private use 2 Ignores this code.
STS 93 Set transmit state Ignores this code.
CCH 94 Cancel character Ignores this code.
MW 95 Message waiting Ignores this code.
SPA 96 Start of protected area Starts the protected area in page memory
that cannot be edited when forms are
created from the host.
EPA 97 End of protected area Ends the protected area in page memory
that cannot be edited when forms are
created from the host.
98 Ignores this code.
99 Ignores this code.
9A Ignores this code.
CSI 9B Control sequence
introducer
Processes as control sequence introducer.
ST 9C String terminator Processes as the closing delimiter of a
string opened by DCS. Also, processes the
code as the end of a line of extended com-
mand characters.
OSC 9D Operating system com-
mand
Ignores this code.
PM 9E Privacy message Ignores this code.
APC 9F Application program
command
Processes the code as the start of a line of
extended command characters.
To Next Page
Loading...