Intermec VT220/ANSI - Page 187

SECTION 8 " Programming
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 8-51
Sequence Description
ESC [ 1; 1 H Home cursor.
ESC [ 2 J Clear screen.
ESC [ ? 10 h Start local editing mode.
ESC V Start protected area.
ESC [ 1 ; 2 H Move cursor to Row 1, Column 2.
ESC [ 1; 17 H Move cursor to Row 1, Column 17.
“Manufacturing” Display literal.
“Receiving” Display literal.
ESC [ 2; 1 H Move cursor to Row 2, Column 1.
“LIP:” Display literal.
ESC [ 1 D Move cursor back one position.
ESC W
End protected area.
ESC [ l C Move cursor forward one position.
ESC F Start selected area.
ESC [ 2; 15 H Move cursor to Row 2, Column 15.
ESC G End selected area.
ESC V Start protected area.
ESC [ 3; 1 H Move cursor to Row 3, Column 1.
“Item:” Display literal.
ESC [ 1 D Move cursor back one position.
ESC W End protected area.
ESC [ 1 C Move cursor forward one position.
ESC F Start selected area.
ESC [ 3; 16 H Move cursor to Row 3, Column 16.
ESC G End selected area.
ESC V Start protected area.
ESC [ 4; 1 H Move cursor to Row 4, Column 1.
“Lot:” Display literal.
ESC [ 1 D Move cursor back one position.