SECTION 9 " Extended Commands
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 9-25
Return Codes for Set Parameters
The Set Parameters return code is the status sent to the
host computer. The wireless station returns data and the
extended command’s status to the host computer in the fol-
lowing format:
\\X<CR>
where “X” is the return code listed in the following chart.
The wireless station simulates the [Enter] key to return the
code to the host.
Code Description Column
0 Good status, transaction complete. (None)
1 Incorrect setting for backlight timer. 4--6
2 Reserved. (None)
3 Incorrect setting for cursor mode. 10
4 Reserved. (None)
5 Reserved. (None)
6 Reserved. (None)
7 Reserved. (None)
8 Incorrect setting for beeper volume. 13--15
9 Incorrect setting for beeper frequency. 16--18
A Incorrect setting for beeper length. 19--21
B Incorrect setting for delete key
mapped to “backspace delete.”
22
C Incorrect setting for carriage return
expansion mapped to “CR/LF.”
23
D Incorrect setting for local host echo. 24
E Incorrect setting for number of screen
rows or alternate screen rows.
25--27
31--33
F Incorrect setting for number of screen
columns or alternate screen columns.
28--30
34--36
To Next Page
Loading...