SECTION 9 " Extended Commands
9-26 VT220/ANSI Terminal Emulation Programmer’s Reference Guide
Examples of Set Parameters
Set Parameters extended command characters can be
started by an APC sequence or by a space.
APC Sequence
When the control character sequence for APC starts data,
all of the data is on Line 1. The control character sequence
is not displayed, which results in a faster transmission rate.
Also, the cursor position is not lost.
The following example shows data started by the control
character sequence for APC. The sequence is prefixed by
the notation “ ^ ” which represents “control.”
^9F#H099bbb4b1000030005101bbb080010080
Column 2 Column 21Column 11 Column 31
Space
The following example shows a space at the start of the da-
ta. A “b” indicates a space.
b#H099bbb4b1000030005101bbb080010080
Column 1 Column 21Column 11 Column 31
Following is an example of data for Set Parameters. A
space starts the data.
To Next Page
Loading...