Invacare STORM - Fitting the Headrest; Fitting the Headrest to the Standard Back

101
8.13 Fitting the headrest
8.13.1 Fitting the headrest to the standard back
Requirements:
• 5 mm Allen key
• 10 mm socket spanner
•
• Gripping it at the base, hold the lower section of the headrest mounting (4) with the clamp
block against the handlebar (3).
• Attach the clamp cover (2.
• Insert the four Allen screws (1) from above through the boreholes.
• Fit the four cap nuts (5) to the screws from underneath.
• Use a 5 mm Allen key and a 10 mm socket spanner to tighten the screws and the cap nuts.
• Fit the headrest in the guide bar.
•