58
8.3.5 Checking the cable
Requirements:
• 4 mm Allen key
•
•
• Remove the rear and the centre cover as described in chapters 8.1.1 and Fehler!
Verweisquelle konnte nicht gefunden werden. .
• Pull the batteries out of the battery compartment as described in chapter 8.3.1.
• Check the fuse cable (1) and battery cable (2) for visible damage and crushing points.
• Replace any damaged cables.
•
• Check all cables for visible damage and crushing locations. Replace any damaged cables.
• Pull each plug (1) carefully. The plug should not come out of the socket.
• If one of the plugs is loose, press it back into the socket with light pressure. The plug must
engage.
• Checked to ensure that the plug is now firmly in its socket. If not, repeat the previous
operation.
To Next Page
Loading...
