77
8.5.4 Replacing the tilt actuator
Requirements:
• Oblique pliers
• Cable ties
Dismantling the tilt actuator:
• Remove the legrests.
• Pull the tilt actuator plug out of the actuator module under the seat
• Unclip the cable. Remove any cable ties which are fitted.
• Remove the upper pin retainer (1).
• Remove the upper pin (2) and tip the tilt actuator forward (5).
• Remove the lower pin retainer (4).
• Remove the lower pin (3) and remove the entire tilt actuator.
• Replace the tilt actuator.
Refitting the tilt module:
• Refit the parts later in reverse order.
• To conclude, check all the mobility aid functions.
•
To Next Page
Loading...
