32
8.1.2 Opening the centre panel
Requirements:
• 4 mm Allen key
Dismantling the centre panel:
• Remove the rear cover as described in chapter 8.1.1.
• If possible, use the lifter to move the seat to the uppermost position.
• Loosen the two Allen screws (1) using a 4 mm Allen key.
• Lift the rear part of the cover carefully and remove the two spacers that are underneath the
cover on the Allen screws.
• Lift off the entire cover. If the mobility aid does not have a lifter, the cover must be bent apart
carefully as shown in the picture on the right.
•
Refitting the centre panel:
• Refit the parts in reverse order.
• Now tighten all the screws finger-tight again.
•
To Next Page
Loading...
