Invacare STORM - Fitting the Headrest to the Easyadapt Back

102
8.13.2 Fitting the headrest to the EasyAdapt back
Requirements:
• 4 mm Allen key
• T30 torx wrench
• 10 mm socket spanner
•
• Loosen the three Allen screws (1) using a 4 mm Allen key, but do not remove the screws
completely.
• Move the back plate (2) outwards.
• Repeat this on the second back plate.
•
• Insert the torx screws from the front through boreholes made in the top of the backrest.