103
• Attach the washers to the torx screws from the rear.
• Fit the headrest holder (3) onto the torx screws.
• Attach further washers to the torx screws.
• Fit the nuts (1) to the torx screws.
• Tighten the torx screws and the nuts using a T30 torx wrench and a 10 mm socket spanner.
• Insert the headrest (4) in the headrest holder.
• Fit the thumb screw (2) and tighten it.
• Move the back plates back to the old width.
• Tighten the three Allen screws on the back plates.
•
To Next Page
Loading...
