84
8.8 Replacing the safety belt
Requirements:
• 10 mm socket spanner
• 4 mm Allen key
Dismantling the safety belt:
• Remove the plastic cap (5).
• Loosen the bolt (3) and the associated nut (in the figure this is covered) with a
4 mm Allen key and a 10 mm socket spanner.
• Remove the nut incl. the washer.
• Remove the screw incl. the safety belt, the washer (2) and the washer arranged behind.
Note
Another nut is fixed between the two washers (2) and (4) as a spacer so that the belt mounting
can rotate freely.
•
• Replace the safety belt (1).
Refitting the safety belt:
• Refit the parts in reverse order.
To Next Page
Loading...
