INVT Goodrive30 VFD Series User Manual

Goodrive30 Series VFD Function parameter list
-74-
Function
code
Name
Description
Default
Modify
protection is disabled.
After the user password is set and takes effect,
you cannot enter the parameter menu if you
enter an incorrect password. Please remember
your password and save it in a secure place.
After you exit the function code editing interface,
the password protection function is enabled
within 1 minute. If password protection is
enabled, "0.0.0.0.0" is displayed when you press
the PRG/ESC key again to enter the function
code editing interface. You need to enter the
correct user password to enter the interface.
Note: Restoring the default values may delete
the user password. Exercise caution when using
this function.
P07.01
Function
parameter
copy
The function code determines the manner of
parameters copy.
0: No operation
1: Upload the local function parameter to the
keypad
2: Download the keypad function parameter to
local address (including the motor parameters)
3: Download the keypad function parameter to
local address (excluding the motor parameter of
P02 group)
4: Download the keypad function parameters to
local address (only for the motor parameter of
P02 group)
Note: After the parameter is set to 1, 2, 3 or 4,
and the operation is executed, the parameter is
automatically restored to 0. The parameters
uploaded or downloaded do not include those of
the P29 group (factory function parameters).
0
◎
P07.02
QUICK/JO
G key
function
selection
0: No function
1: Jog. Press QUICK/JOG to begin the jogging
running.
2: Switch the display state by the shifting key.
Press QUICK/JOG to shift the displayed function
1
◎

INVT Goodrive30 VFD Series Specifications

General

Brand	INVT
Model	Goodrive30 VFD Series
Category	Inverter
Language	English