Verification: By checking the relevant drawings, instruction
handbook, inspection of the machine and relevant
functional testing of the machine.
The principles of EN ISO 12100:2010, 6.4 shall be
observed and the requirements of Clause 7 of EN 847-
1:2013 apply.
Information on negative test result of braking system shall
be displayed.
Verification: By checking the relevant drawings and
inspection on the machine.
The principles of EN ISO 12100:2010, 6.4.4 shall be
observed and in addition:
The following information shall be marked legibly and
indelibly throughout the expected life of the machine
either directly on the machine e.g. by engraving, etching
or by using labels or plates permanently fixed to the
machine e.g. by riveting or stickers:
a) business name and address of the machine
manufacturer and, where applicable, of his authorized
representative;
b) year of construction, that is the year in which the
manufacturing process is completed;
c) designation of the machinery and designation of series
or type;
d) machine identification or serial number (if any);
e) rating information (mandatory for electro-technical
products: voltage, frequency, power, in accordance
with EN 60204-1:2006, 16.4);
f) maximum and minimum diameter of the saw blades for
which the machine is designed;
g) direction of rotation of the saw blade(s);
h) bore diameter of the saw blade (s);
To Next Page
Loading...
