Test Report No.: 17702074 003
Part I of II
machine's centre of gravity.
If graphical symbols related to the operation of actuators
are used, they shall be in accordance with Table A.1 of
EN 61310-1:2008.
Further guidance is given in EN 60204-1:2006, EN 614-
1:2006+A1:2009 and EN 614-2:2000+A1:2009.
Also see 5.2.2 for position of controls, 6.3, EN 894-
3:2000+A1:2008 and EN 1005-3:2002+A1:2008.
Circular saw benches and building site saws components
with a mass exceeding 25 kg shall include necessary
attachments to accommodate the fitting of a lifting device
e.g. lugs positioned such as to avoid their overturn or fall
or move in an uncontrolled way during transport,
assembly, dismantling, disabling and scrapping.
Verification: By checking the relevant drawings, inspection
of the machine, measurement and relevant functional
testing of the machine.
For circular saw benches fitted with pneumatic workpiece
clamping the requirements of EN ISO 4414:2010 shall
apply.
Also see 5.2.1, 5.2.2, 5.3.3.1, 5.4.12, 6.1, 6.2 and 6.3.
Verification: By checking the relevant drawings, and
inspection of machine.
Electromagnetic compatibility
The machine shall have sufficient immunity to
electromagnetic disturbances to enable it to operate
correctly in accordance with EN 60439-1:1999, EN 50370-
1:2005 and EN 50370-2:2003.
NOTE Machines which incorporate CE-marked electrical
components and where such components and cabling are
installed in accordance with their respective manufacturers
instructions, are generally considered to be protected against
external electromagnetic interference.
Verification: By checking the relevant drawings and/or
circuit diagrams and inspection of the machine.
No sensitive parts to
electromagnetic
disturbance.
If the machine is fitted with a laser to indicate the cutting
line, the laser shall be of category 2, 2M or a lower risk
To Next Page
Loading...
