Test Report No.: 17702074 003
Part I of II
position of the saw blade (see Figure 19).
When necessary the correct vertical position of the riving
knife to fulfil this requirement has to be indicated, e.g. by
a marking on the riving knife in the level of the machine
table. The maximum cutting height shall be less than the
maximum saw blade projection above the table.
The mounting and dismounting of saw blade guard on the
riving knife shall be possible without the aid of a tool.
The in-feed end of the base of the saw blade guard shall
have a “lead-in” in order to avoid misfeeding should the
saw blade guard be incorrectly set or the workpiece be
uneven. If the saw unit is fitted with the maximum saw
blade and raised to the maximum cutting depth and the
saw blade guard is lowered to the machine table the lead
Max. cutting height 77mm.
H=30mm
α =42°.
To Next Page
Loading...
