Test Report No.: 17702074 003
Part I of II
components shall not be capable of being fitted to
the support at the same time except in the case of
machines with a maximum saw blade diameter of
200 mm, where they may consist of two parts which
can be fitted together but shall be removable
without the aid of a tool;
e) have a height B
between 5 mm and 15 mm in its low
position (see Figure 14) and in its high position a
minimum height A of the workpiece guiding part of:
1) A ≥ 90 mm with saw blades with a diameter > 315
mm;
2) A ≥ 50 mm with saw blades with a diameter ≤ 315
mm;
3) A ≥ 30 mm with saw bl ades with a diameter ≤ 200
mm.
A=65mm. B=14mm. (Max.
saw blade diameter:
254mm.)
f) be so designed that when it is in the low position, the saw
blade shall not be capable of touching the rip fence at
point A as shown in Figure 15 when the saw blade is fully
tilted;
To Next Page
Loading...
