Test Report No.: 17702074 003
Part I of II
Verification: By checking the relevant drawings, inspection
of the machine and measurement.
c) riving knife shall be capable of vertical adjustment so
that its tip reaches a level 2 mm below the highest point
on the periphery of the saw blade or higher when set in
accordance with the requirements of 5.3.5 d) (see
Figure 7) (also see 6.3 l));
Verification: By checking the relevant drawings, inspection
of the machine and measurement.
d) riving knife shall be designed so that when it is
mounted and adjusted so that its closest point to the
saw blade is 3 mm, then at no point shall the gap
between the saw blade and the riving knife be greater
than 8 mm, measured radially through the centre of the
saw spindle in the area above the table (see Figure 8);
Verification: By checking the relevant drawings, inspection
of the machine and measurement.
To Next Page
Loading...
