Test Report No.: 17702074 003
Part I of II
61310-1:2008.
If the machine is equipped with scales the requirements
of EN 894-2:1997+A1:2008 shall apply.
The scale for indicating the cutting width shall be so
designed and positioned that the adjusted cutting width is
indicated and easily legible.
Verification: By checking the relevant drawings and
inspection of the machine.
Riving knives shall be permanently marked with:
a) its thickness;
b) range of saw blade diameters for which it is intended;
c) width of the riving knife mounting slot.
For riving knife with saw blade guard mounting a line to
indicate the correct limit position of the top guard shall be
marked (see 5.3.7.1.2).
Permanently marked means e.g. engraving, etching,
embossing or stamping.
Verification: By checking the relevant drawings and
inspection of the machine.
The principles of EN ISO 12100:2010, 6.4.5 shall be
observed and in addition the instruction handbook shall
include at least:
a) repetition of the markings, pictograms and other
instructions on the machine and, if necessary,
information about their meaning as required in 6.1 and
6.2;
b) intended use of the machine including reasonably
foreseeable misuse which includes working without the
saw blade guard or the protective device for grooving in
the protective position;
c) warning regarding residual risks as:
1) warning to take precautions to reduce the hazard of
inhalation of harmful dusts (e.g. wearing a dust
mask);
To Next Page
Loading...
