Test Report No.: 17702074 003
Part I of II
Verification: By checking the relevant drawings,
measurement and inspection of the machine.
Circular saw benches with sliding table
For circular saw benches equipped with a sliding table
and/or where provision is made for the use of a sliding
table, the electrical control devices for normal stopping
and emergency stop (if provided, see 5.2.5) shall be
situated in the shaded area marked Y in Figure 4, or on a
movable control panel.
Verification: By checking the relevant drawings,
measurement and inspection of the machine.
Before starting the saw blade(s) all interlocked guard(s)
(where fitted as indicated in 5.3.7) shall be in place and
functional. This is achieved by the interlocking
arrangements described in 5.3.7.
Start or restart shall only be possible by actuation of the
start control device provided for that purpose.
Closure of movable interlocked guards shall not lead to an
automatic restart of hazardous movements.
The safety related part of the control systems (also see
5.2.1) for starting and the interlocking arrangements as
indicated in 5.2.7, 5.2.8, 5.3.6, 5.3.7 shall be at least PL=c
No interlocking guards.
PL=c for start control.
To Next Page
Loading...
