Jet JTS-600X - Jts600

Test Report No.: 17702074 003
Part I of II
Page 68 of 72
EN 1870-19:2013
Clause
Requirement
Remarks - Results
Verdict
G.3
Riving knife mounted saw blade guards
P
The test load shall be applied to the saw blade guard at
the upper edge of the lead-in when the saw blade guard is
lowered to the machine table and the saw unit is adjusted
to the maximum cutting height for which the machine is
designed (see Figure G.3).
The measuring point for the deflection is at the same level
as the application point of the load.
The deflection D of the saw blade guard shall be ≤ 15 mm
under a test load F of 5 N for circular saw benches and
building site saws with a maximum saw blade diameter of
315 mm. For building site saws with a maximum saw
blade diameter over 315 mm the deflection D shall not
exceed 8 mm under a test load F of 20 N.
The saw blade shall not touch the guard.
Test carried out.
D=11mm with a force of
5N.
Test equipment as below:
1. Weight:
N038, 500g, SN:381,
Calibration due:2014-09-27
2.Tape Ruler:
N106, 0-5m,
Calibration due:2014-10-09
P