Jet JTS-600X - Jts600

Test Report No.: 17702074 003
Part I of II
Page 66 of 72
EN 1870-19:2013
Clause
Requirement
Remarks - Results
Verdict
The minimum dimensions of the machine table, extension
table and table insert of building site saws (see Figure
F.1) shall be in accordance with the requirements of
Table F.2.
N/A
Annex G
Saw blade guard stability test
P
G.1
General
P
All tests shall be performed without a saw blade fitted to
the machine.
N/A
G.2
Separately from riving knife mounted saw blade
guards
N/A
G.2.1
Saw blade guards with lead-in
N/A
The test loads shall be applied to the saw blade guard 40
mm above the furthermost point of lower edge which is
parallel to the table (see Figure G.1).
The measuring point A shall be located at the same point
where the test load is applied (see Figure G.1).
The measuring point B shall be located at a point on the
top edge directly above the saw blade spindle axis (see
Figure G.1).
N/A