Test Report No.: 17702074 003
Part I of II
e) front and rear contours of the riving knife shall be
continuous curves or straight lines, without any flexure
which would weaken it (e.g. see Figure 9);
Verification: By checking the relevant drawings and
inspection of the machine.
f) riving knife mounting arrangement shall be such that
the relative position of the riving knife and the rear saw
flange is in accordance with the tolerance shown in
Figure 10. The relative position of the riving knife and
the rear saw blade flange shall be maintained with the
rise, fall and tilt of the saw blade;
Verification: By checking the relevant drawings, inspection
of the machine, measurement and relevant functional
testing of the machine.
To Next Page
Loading...
