i) width of the riving knife guiding elements adjacent to
the mounting position of the riving knife;
j) on machines where speed changing is achieved by
changing the position of the drive belts on the drive
pulleys, with a diagram in rpm adjacent to the pulleys or
on a door giving access to the belt drive mechanism
showing the relevant speed in rpm selected for each
combination of pulleys;
k) on circular saw benches fitted with a de-mountable
sliding table the mass of the table;
l) where the machine is fitted with a pneumatic system
the nominal pressure for the pneumatic circuits;
m) on circular saw bench with tiltable saw blade a
pictogram meaning the following: "Change the saw
blade guard before tilting the saw blade";
n) where the machine is fitted with a pneumatic isolator its
function, location and operational position(s) e.g. by a
label or a pictogram;
o) on building site saws the guaranteed sound power level
determined in accordance with the methods given in
5.4.2.2.2 a) to d) using the single number form of
declaration in accordance with EN ISO 4871:2009;
p) where the circular saw bench is equipped with a
pneumatic supply and isolation of the pneumatic
energy supply is not achieved by the electrical isolation
a permanent warning label shall be placed in proximity
to the electrical supply disconnection device, warning
that the pneumatic supply is not isolated by isolating of
the electrical supply;
q) machines with different spindle speed shall have the
indicated speed in rpm.
The labels or pictograms for marking the nominal
pressure and the isolators shall be fitted in a position in
close proximity to the installed location of the isolators on
the machine.
The markings shall either be in the language of the
country in which the machine is to be used or wherever
possible by using pictograms.
If graphical symbols related to the operation of actuators
are used they shall be in accordance with Table A.1 of EN
To Next Page
Loading...
