Test Report No.: 17702074 003
Part I of II
Verification: By checking the relevant drawings, inspection
of the machine and measurement.
i) riving knife shall be held in position by guiding elements,
e.g. guiding pins (see Figure 12). The riving knife fixing
slot shall be no more than 0,5 mm wider than the
guiding elements;
Verification: By checking the relevant drawings, inspection
of the machine and measurement.
j) where it is necessary to change the riving knife to
accommodate different diameters of saw blade, the
riving knife fixing slot shall be open ended.
Verification: By checking the relevant drawings and
inspection of the machine.
To Next Page
Loading...
