Jet JTS-600X - Jts600

Test Report No.: 17702074 003
Part I of II
Page 62 of 72
EN 1870-19:2013
Clause
Requirement
Remarks - Results
Verdict
from country to country. This information, however, will
enable the user of the machine to make a better
evaluation of the hazard and risk.";
Information on noise emission shall also be provided in
the sales literature when performance data are provided.
ff) information on conditions necessary to ensure that
throughout the foreseeable lifetime the machine
including its components cannot overturn or fall or
move in an uncontrolled way during transport,
assembly, dismantling, disabling and scrapping;
Checked ok.
P
gg) the operating method to be followed in the event of
accident or breakdown; if a blockage is likely to occur,
the operating method to be followed so as to enable
the equipment to be safely unblocked;
Checked ok.
P
hh) the identification data of the spare parts to be
changed by the user, when these affect the health and
safety of operators (parts to be changed only by the
manufacturer or personal charged by the
manufacturer are excluded);
Checked ok.
P
ii) information on how to provide protection of people
against electrical shock due to indirect contact in the
machine by a device for automatic disconnection of the
power supply to be installed by the user in the line
powering the machine (RCD);
Checked ok.
P
jj) description of fixed guards which have to be removed
by the user for maintenance and cleaning purposes
(guards to be dismounted only by the manufacturer or
personal charged by the manufacturer are excluded);
N/A
kk) information on the use of safety appliances provided
according to 5.3.9.
Checked ok.
P
ll) design specifications for the protective device for
machines with riving knife mounted saw blade guard
shall be given: such protective device shall be made
out of chip able material; of a length of 400 mm; of a
dimension square to the parallel fence of at least 200
mm.
N/A
Verification: By checking the instruction handbook and
relevant drawings.
--
Annex A
Stability test
N/A
The machine shall be set in its loading positions on a
chipboard inclined downwards at 8° in the direction of
cutting stroke. The force F
1
= 100 N shall be applied to
the table edge in the plane parallel to the table and in the
direction of cutting. The machine shall not move.
The test is repeated with the force F
2
= 300 N. If the
machine is moving, a fence shall be applied on the
chipboard. The machine shall not tilt.
N/A