Jet JTS-600X - Jts600

Test Report No.: 17702074 003
Part I of II
Page 3 of 72
EN 1870-19:2013
Clause
Requirement
Remarks - Results
Verdict
d) emergency stop: PL=c (see 5.2.5);
e) interlocking of guards: PL=c (see 5.2.8, 5.3.7.3);
f) interlocking of functions: PL=c (see 5.2.8, 5.2.3,
5.3.7.3);
g) detecting of the selected speed of the main saw blade:
PL=b or PL=c (see 5.2.6);
h) speed control of the main saw blade drive if fitted :
PL=c (see 5.2.6);
i) hold-to-run control circuit: PL=c or P=b in conjunction
with an initiation control device in PL=c (see 5.2.7,
5.3.7.4);
j) power operated adjustment of the saw blade(s) or
fence(s): PL=b (see 5.2.7);
k) power operated adjustment movements initiation: PL=c
(see 5.2.7);
l) braking system: PL=b or PL=c (see 5.3.4.1);
m) powered workpiece clamping system: PL=c (see
5.3.7);
Verification: By checking the relevant drawings and/or
circuit diagrams and inspection of the machine.
5.2.1.2
Use of protective devices
No protective device used.
N/A
Protective devices shall be in accordance with the specific
standards. For the devices listed below, the following
requirements apply:
a) magnetic/proximity switches shall be in accordance
with the requirements of EN 1088:1995+A2:2008, 6.2
and the related control system shall be at least PL=c in
accordance with the requirements of EN ISO 13849-
1:2008;
b) if a time delay is used it shall be at least PL=c in
accordance with the requirements of EN ISO 13849-
1:2008
Also see 5.4.7 for the EMC requirements on the complete
machine.
Verification: By checking the relevant drawings and/or
circuit diagrams, inspection of the machine, measurement
and relevant functional testing of the machine.
NOTE For the components characteristics a confirmation