10
Setup adjustments of the sawblade
shall never be performed when the
machine is running.
Use the front hand wheel to raise the
sawblade (one turn of the handwheel
equals to approximately 3 mm of
height setting).
Use the right hand wheel to tilt the
sawblade.
Both 45° and 90° positive stops are
factory set.
Start the machine with care.
7.5 Sliding table setup
Sliding table setup shall never be
performed when the machine is
running.
When loading panels and when rip
cutting the sliding table must be
locked.
It is recommended to clean the sliding
table once a week, and to remove all
sawdust and chips which gradually
slow down the sliding table.
Never use oil or grease!
7.6 Rip fence setup
Rip fence setup shall never be
performed when the machine is
running.
Note:
The rip fence profile can be placed flat
and adjusted in length.
-The cutting of small work pieces
(width less than 120mm) shall only be
performed with the rip fence profile
placed flat (Fig 22).
Fig 22
When cross cutting using the rip
fence, to avoid the wood getting stuck
between the fence and the riving knife
(resulting in a highly dangerous
kickback) it is necessary to position
the fence so that its end corresponds
with the front of the sawblade (Fig 23).
Fig 23
Start the machine with precaution.
7.7 Blade tilt 45° and 90° positive
stop adjustment
The blade tilt positive stops can be
adjusted with an allen key (Fig 24).
Fig 24
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Inspect the proper function of the dust
extraction daily.
Keep the inside of the cabinet clear of
sawdust and wood chips. Make sure
the motor fan and fan cover are also
kept clear of sawdust.
All protective and safety devices must
be re-attached immediately after
completed cleaning, repair and
maintenance work.
Defective safety devices must be
replaced immediately.
A worn table insert must be replaced.
Removal of dust chute blockage:
Cut off pieces can block off the chip
flow in the lower saw guard.
Disconnect the machine form the
power source, pull mains plug.
Loosen screws, lift and remove the
front cabinet cover (CC, Fig 25).
Fig 25
Remove the lock knob (GG, Fig 26)
and lower the dust port (BB).
Fig 26
Remove blocking parts.
Reinstall the dust port and front
cabinet cover immediately.
Cleaning:
Clean the machine regularly.
To Next Page
Loading...
