98
IGNITION
FLYWHEEL SERVICING
Apply Moly Lube to threads of pressing screw and
center hole of crankshaft.
Assemble the following components from Univer-
sal Puller Set, P/N 378103:
• Body, P/N 307636
• Pressing Screw, P/N 307637
• Handle, P/N 307638
• Three screws, P/N 307641
• Three washers, P/N 307639
Install the puller on flywheel with body flat side up.
Seat the shoulder screws completely. Hold puller
by its handle, and tighten pressing screw until fly-
wheel releases.
Installation
Install the flywheel key with its outer edge parallel
to taper of crankshaft.
Clean the crankshaft and flywheel tapers with
Cleaning Solvent and let dry. These surfaces must
be clean and dry to allow proper locking of the
tapers.
Align the flywheel keyway and install flywheel.
Coat the threads of the flywheel nut with Gasket
Sealing Compound. Install the nut and torque to
the correct value. See chart below.
32845
TYPICAL
1. Body
2. Pressing screw
3. Handle
4. Screws (3)
5. Washers (3)
32846
4
3
2
1
5
DR2115
Model Ft. lb. N·m
9.9/15 45 to 50 60 to 70
32911
To Next Page
Loading...