JRC RADAR 1800 - Alarm; NAV ALARM (Navigation Alarms)

105
Section 3 Operation
Note:
•If invalid data are received, the message “ERROR!” appears. In this case,
check again whether the data are broken.
ALARM
•Press
MENU
MENU
, select “ALARM SETTING>”, and press
Joystick
, the
“ALARM SETTING” menu is displayed.
NAV ALARM (Navigation alarms)
•Select “NAV ALARM>”, and press
Joystick
, the “NAV ALARM”
menu is displayed.
ARRIVAL (Arrival Alarm)
•When turned on, this alarm shows a message on the screen and also
sounds the buzzer when the distance between your vessel and the
waypoint displayed in the NAVIGATION window becomes equal to
or less than the operator’s preset value.
ANCHOR (Anchor Alarm)
•When turned on, this alarm shows a message on the screen and also
sounds the buzzer when the distance your vessel and the waypoint
displayed (usually anchor drop point) in the NAVIGATION window
becomes equal to or greater than the operator’s preset value.
NAV ALARM
OFF 0.01
OFF 0.01
OFF 0.01
__ __ __ __
__ __ __ __
OFF 0.1
OFF 0.1
OFF 0.1
OFF
ARRIVAL
ANCHOR
OFF
- COURSE
ZONE
SPEED UPPER
SPEED LOWER
TRIP
DGPS
ON
NAV ALARM >
RADAR ALARM >
TEMP. ALARM >
CLOCK ALARM >
BUZZER
ALARM SETTING
ATTENTION
While receiving data, the transmission and
reception to/from GPS and that of the NMEA
data are terminated.