JRC RADAR 1800 - PLANNED ROUTE (Navigating according to a planned route); TEMPORARY ROUTE (Navigating according to a temporary route)

74
Section 3 Operation
SELECT ROUTE
WAYPOINT DIRECT
PLANNED ROUTE
TEMPORARY ROUTE
NEAREST PORT
PREVIOUS MOB
START NAVIGATION
BEGIN NAVIGATION
ACCORDING TO THE
SELECTED ROUTE.
ARE YOU SURE?
YES NO
In the RADAR/CHART display
[RADAR/CHART screen mode]
•Press
RANGE
RANGE
to display four Soft Keys.
ZOOM
IN
ZOOM
OUT
RANGE
-
RANGE
+
ZOOM
IN
Magnify the chart.
ZOOM
OUT
Reduce the chart.
RANGE
-
Decrease the range scale. The minimum range scale is
0.125NM.
RANGE
+
Increase the range scale. The maximum range scale is
24nm.
The range rings are automatically set to correspond with this selection.
Navigation Setting
• While not navigating to a waypoint or following a route, press
NA
NA
V
to display four Soft Keys
SELECT
ROUTE
,
SEQUE -
NCE
,
WPT
STEP
, and
TEMP
ROUTE
.
• While proceeding on waypoint/route navigation, press
NA
NA
V
to
display four Soft Keys
NEXT
WPT
,
PREV.
WPT
,
STOP
NAV
, and
TEMP
ROUTE
.
SELECT
ROUTE
(Selecting Navigation)
Press the
SELECT
ROUTE
Soft Key to display the SELECT
ROUTE menu.
WAYPOINT DIRECT (Selecting a waypoint)
• Select WAYPOINT DIRECT to display the WAYPOINT LIST
screen and two Soft Keys
NEW
WPT
and
JUMP
.
• Select a waypoint and press the
Joystick
to start the navigation to the
selected waypoint.
• To make registration of a new waypoint, press the
NEW
WPT
. (Refer to
“Storing a waypoint” p.80)
• To search a waypoint in waypoint lists, press the
JUMP
and set page
number by popup menu.