93
Section 3 Operation
DEPTH CONTOUR
•In this menu, you can enable visualization of depth contour and
setting range.
DETAILED
•In this menu, you can select the detaile about chart presentation.
Normal : normal detaile
high : high detaile
GRAPH SETTING
•In this menu, you can set the scale of the water depth, temperature,
and speed graphs.
Notes:
•To display the water depth graph, it is necessary to receive the depth data
in the NMEA0183 standard format. You need to connect the specified
signal line to the NMEA connector on the rear panel to receive the water
depth data.
•To display the water temperature graph, it is necessary to receive the depth
data in the NMEA0183 standard format. You need to connect the
specified signal line to the NMEA connector on the rear panel to receive
the water temperature data.
•Graphs are not displayed in the Radar Full screen and the Radar/Chart
screen.
GRAPH DISPLAY (Selecting what to display)
•In this menu, you can select what to display from among temperature,
depth, and speed.
DEPTH SCALE (Setting a display range of the water
depth graph)
•In this menu, you can select the scale center and scale range. The scale
center indicates the center value in the water depth graph scale, and
the scale range indicates the width.
TEMP. SCALE (Setting a display range of the
temperature graph)
•In this menu, you can select the scale center and scale range. The scale
center indicates the center value in the temperature graph scale, and
the scale range indicates the width.
SPEED SCALE (Setting a display range of the speed
graph)
•In this menu, you can select the scale center and scale range. The scale
center indicates the center value in the speed graph scale, and the scale
range indicates the width.
GRAPH SETTING
DEPTH
50
100
60
20
20
40
GRAPH DISPLAY
DEPTH SCALE
TEMP. SCALE
SPEED SCALE
To Next Page
Loading...
