JRC RADAR 1800 - Navigation Setting; SELECT ROUTE (Selecting Navigation); WAYPOINT DIRECT (Selecting a waypoint)

73
Section 3 Operation
MAN OVERBOARD!
BEGIN NAVIGATION
TO THE MAN
OVERBOARD POINT.
ARE YOU SURE?
YES NO
CDI RANGE
0.1 0.3 0.5 NM
Man Overboard
• Press the
MOB
MOB
key to place the marker at the own ship’s position.
• Press the
Joystick
to the left or right to select YES or NO and push it
to complete the selection.
Notes:
•Each time you press the
MOB
MOB
key, the memory data of the MOB’s
position is updated.
•When navigation begins toward the MOB, the alarm of
MOB
is
displayed.
Cancel the navigation in order to terminate the alarm display.
(Refer to “Stop Navigation” p.79)
•Requires NMEA position/heading inputs.
Range Setting
In the CHART display
• Press
RANGE
RANGE
to display two Soft Keys
ZOOM
IN
and
ZOOM
OUT
.
ZOOM
IN
Press the
ZOOM
IN
Soft Key to magnify the chart.
ZOOM
OUT
Press the
ZOOM
OUT
Soft Key to reduce the chart.
In the CDI/COMPASS display
• Press
RANGE
RANGE
to display the CDI RANGE popup menu.
• You can set the display range of the highway window displayed in
CDI/COMPASS.
• Press the
Joystick
to the left or right to select 0.1 NM, 0.3 NM, or
0.5 NM.
In the RADAR display
[RADAR full screen mode]
•Press
RANGE
RANGE
to display two Soft Keys.
RANGE
-
RANGE
+
RANGE
-
Decrease the range scale. The minimum range scale is
0.125NM.
RANGE
+
Increase the range scale. The maximum range scale is
24nm.
The range rings are automatically set to correspond with this selection.