Section 2 Installation
37
Connecting Electronic Compass/ GPS
Compass (Option)
By connecting the NMEA-183 formatted output (HDM) or the optional
GPS Compass (JLR-10), the realtime and precise course information is input and
you can use more precise North-Up or Course-Up mode.
Connection
CFQ-6532(Power Cable)
RED
BLK
YEL
GRN
RED: Ship’s main
BLK: Ship’s main
YEL: Compass Data
GRN: Compass Data
From GPS Compass
or Magnetic Compass
Initial Operation and Set-up
Inspection after Installation
After completing the installation and prior to energizing the equipment, it is
necessary to ensure that all steps of the installation were accomplished in
accordance with the instructions. Make sure that:
q The cables are not pinched or damaged.
w The allowed voltage is not exceeded and the polarity is correct.
e All bolts are tight.
r The power cable shields have been properly connected to Boat Main ground.
Figure 2-12
To Next Page
Loading...
