53
Section 3 Operation
WIND DATA Mode
To display the wind display with numerical data, it is necessary to
receive the wind direction/speed data and the vessel reading/course data
from external navigation aids.
Notes:
•To display the wind data, it is necessary to receive the wind data in the
NMEA0183 standard format. You need to connect the specified signal
line to the NMEA connector on the rear panel to receive the wind data.
•Skipped WIND Mode if there is no wind data.
Vessel’s Information/Waypoint’s
Information
•Press
MENU
to display the following menu. Press soft Key 1 and
the status at the top of the screen changes. To change to the next
status, push
MENU
again, and it can be changed by pressing Soft
Key 1.
VESSEL
INFO 1
FIND
(Soft Key 1)
GRAPH
ON
(Soft Key 2) (Soft Key 3) (Soft Key 4)
VESSEL
INFO 1
Information about your vessel’s position, course, speed,
and the GPS/DGPS status is displayed.
N 42° 34.255'COG122.3° T DGPS
W122° 19.487'SOG 25.5KTS
VESSEL
INFO 2
Information about your vessel’s course, speed, tripped
distance, water temperature, and the GPS/DGPS status
is displayed.
COG122.3° T TRIP 25.8NMDGPS
SOG 25.5KTS TEMP 17.5°C
Note:
•Temperature data is displayed when received the water temperature data
from an external water temperature gauge.
VESSEL
INFO 3
Information about your vessel’s course, speed, water
depth, and the GPS/DGPS status is displayed.
COG122.3° DEP DGPS
SOG 25.5KTS
9999.9
FT
Note:
•Information about the depth of the water is displayed when it has been
attained.
To Next Page
Loading...
