71
Section 3 Operation
Plotter Operation
Using The Joy Stick in CHART
mode
Enter the Event
You can enter the EVENT symbol at the own ship’s position.
• Confirm the shape of cursor mark as “
”. (Don’t move the cursor
mark)
• Press the
Joystick
to display the four soft keys and press the
or
PURPLE
soft key to select the shape or color of the symbol.
• Press the
Joystick
and the EVENT symbol appears at own ship
position.
Enter the WAYPOINT or the MARK
You can enter the WAYPOINT or MARK by moving the cursor
and them pressing the
Joystick
. (Confirm the shape of the cursor is
“+”) You can also use various functions such as Direct Navigation
(GOTO) and Object Information with the four soft keys displayed on
the bottom of the display. These functions can be changed by selecting
them in the MENU-INSTALLATION-OPERATION-J-STICK
PUSH operation modes.
Enter the WAYPOINT
You can enter the WAYPOINT on pointed position by cursor
while selected the Joystick operation mode was “WAYPOINT”.
Storing a waypoint
•Select a point you want to store as a waypoint. Press the
Joystick
to
move the cursor to select a point and push it in to complete the
selection.
•Press the
Joystick
to the left or right to select an item
Name: You can enter up to eight characters.
Comment: You can enter up to 23 characters.
•Press the
Joystick
to store the waypoint, to cancel, press CLR/OFF.
Notes:
• The smallest number is selected among unoccupied numbers.
•If there is no more memory to store a waypoint, the following message
appears.
•Press any key to delete the message, or it goes off automatically in about
seven seconds.
To Next Page
Loading...
