97
Section 3 Operation
INSTALLATION
•This menu includes various settings required for installation, such as
the selection of the external data input method and unit, or the initial
setting of the GPS/DGPS antenna. After installing the RADAR 1800,
use this menu to make your settings.
SIMULATION (Turning the simulator ON/OFF)
•In this menu, you can turn on or off the simulator.
•The simulator provides navigation information such as radar echo,
vessel position, vessel speed, course using the dummy data stored
initially in the RADAR 1800. While the simulator is activated, you
can simulate almost all operations except the operation of the
INSTALLATION menu and radar control.
INITIAL POSITION (Setting the standard position of
the chart display)
•In this menu, you can set the standard position of the chart display
when no navigation aid is connected.
CLOCK ADJUST (Adjusting the date and time)
•In this menu, you can adjust the date and time displayed on the
screen.
DATE & TIME (Selecting a system of time)
•In this menu, you can select 12-hour or 24-hour system and display
OFF.
RADAR ADJUST (Adjusting the radar)
•In this menu, you can set operation condition and adjust the tuning,
the relative alignment, and the display timing of RADAR 1800.
[EBL BEARING]
•You can select the EBL bearing reading relative or true.
(Refer to “Bearing Measurement” p.60)
OFF
N 0° 00.000’
E 0° 00.000’
00/00/0000
00:00
12HOUR
SIMULATION
INITIAL POS.
CLOCK ADJUST
DATE & TIME
RADAR ADJUST>
DATA IN/OUT >
UNITS >
CALIBRATION >
OPERATION >
INSTALLATION
EBL BEARING
PRF SHIFT
BEARING
DISPLAY TIMING
TUNE PRESET
STC PRESET
RADAR ADJUST
REL
20
0
561
32
57
To Next Page
Loading...
