JRC RADAR 1800 - Constructing a rectangle

86
Section 3 Operation
Notes:
• The same names as the waypoint is automatically set and no comment is
entered.
•If memory is not enough, the following message appears.
•Press any key or wait about seven seconds to delete the message.
DIVIDE
Press the
DIVIDE
Soft Key to display the DIVIDE
menu.
You can set the condition for the calculation of the
waypoints.
CONDITION: DIST, ANGLE, DIST & ANGLE or
POINT, XTE
DIST INTERVAL: 0.1 - 99.9 NM
TURNING ANGLE: 10 - 180 °
POINTS: 1 - 98
XTE: 0.01 - 1.00
CONST -
RUCT
(Constructing a Line/Rectangle)
•Press the
CONST -
RUCT
Soft Key to display the
LINE
and
RECT.
Soft Keys.
Construction
Constructing a line
•You can construct a line in the chart.
•Press the
LINE
Soft Key to enter the LINE mode and display the
COLOR
,
END
, and
DELETE
Soft Keys. Move the cursor to the
start point and press the
Joystick
, and move the cursor to end point
and press the
Joystick
again. While you are moving the cursor after
you press the
Joystick
once, a dotted line appears and it changes to a
solid line when you press the
Joystick
. In the similar way, you can
construct another line.
•Press the
END
Soft Key to complete the construction.
Note:
•To delete a constructed line, move the cursor to the start point, a turning
point, or the end point and press the
DELETE
Soft Key.
TRACK-ROUTE CONVERT
DIST & ANGLE
16.5NM
20°
8
0.01
CONDITION
DIST INTERVAL
TURNING ANGLE
POINTS
XTE
MEMORY FULL!
CANNOT REGISTER
THE ROUTE.
ERASE ANY REGISTRY.