96
Section 3 Operation
WAAS SETTING
•In this menu, youcan perform the basic settings of the WAAS module
of the DGPS sensor.
Note:
•Use TX COMMAND to send the values in the following setting.
MODE: AUTO/MANUAL
•Select a method to input differential data, either beacon receiver/
WASS satellite or some other automatic method.
RANGING: ON/OFF
•Select whether the differential data transmission satellite to also be
used as the positioning satellite.
NG WAAS: NO USE/USE
•Select whether to use the test satellite or the disable satellite.
WAAS NO.: AUTO/120 to 138
•Select whether to input the number of the satellite to be used or do it
automatically.
WAAS SETTING
AUTO
ON
NO USE
AUTO
MODE
RANGING
NG WAAS
WAAS NO.
TX COMMAND
To Next Page
Loading...
