Section 2 Installation
25
SECTION 2
Installation
WARNING
This display unit produces heat. Do not install it in a
poorly ventilated or excessively hot area. Doing so
may cause burns or defects.
Do not install the equipment at a location where it is
constantly splashed with water. If the equipment is
splashed with water, immediately wipe with a dry
cloth. Leaving the equipment in this condition may
cause electric shock or malfunction.
CAUTION
Installing the Display Unit
Choosing a Location for Installation
The two most important considerations for mounting the RADAR 1800
Color Radar/Plotter display unit are:
•Choosing the best location for operating and viewing
•Protecting the unit from the environment
Standard Mounting
Typically the unit can be mounted with its yoke assembly to a chart tabletop
location. Figure 2-1 shows the recommended clearances for yoke mounting.
Affix the Display Unit to a hard wooden or metal
plate with the specified screws when mounting it to
a tabeltop or suspending it. Otherwise the Display
Unit, weighting 2.8 kg may drop, causing injury or
damage.
To Next Page
Loading...
