JRC RADAR 1800 - Vessel’s Information;Waypoint’s Information

52
Section 3 Operation
[Numeric Data]
DPT : Depth
SOG : Speed (Over Ground) (unit: KTS=knots, KPH=km/hour,
MPH=mile/hour)
WPT: Waypoint ID
COG:Vessel course over ground (unit: degree/ T=true,
M=magnetic)
BRG : Bearing to destination (unit: degree/ T=true, M=magnetic)
RNG: Distance to destination (unit:0.1 NM)
XTE : Cross track error. Deviation from course and direction to
steer (unit:0.1 NM)
Steering required to return to the planned course is indicated
t (Left) and s (Right)
Notes:
•To display the vessel heading marker and HDG (Vessel heading), it is
necessary to receive the vessel heading data in the NMEA0183 standard
format. You need to connect the specified signal line to the NMEA
connector or DC12V/ COMPASS connector on the rear panel to receive
the vessel heading data.
•To display the water depth data, it is necessary to receive the depth data in
the NMEA0183 standard format. You need to connect the specified signal
line to the NMEA connector on the rear panel to receive the water depth
data.
NUM DATA Mode
Select NUM DATA to display the numeric display. The numeric
display includes the numerical data of various navigation information
such as water depth, vessel speed, course, heading direction, deviation
from the course, your vessel’s position, and so on. To display the
information mentioned above, however, it is necessary to connect a
GPS/DGPS sensor (optional) and activate Navigational equipment.
Notes:
•To display the vessel heading marker and HDG (Vessel heading), it is
necessary to receive the vessel heading data in the NMEA0183 standard
format. You need to connect the specified signal line to the NMEA
connector or DC12V/ COMPASS connector on the rear panel to receive
the vessel heading data.
•To display the water depth data, it is necessary to receive the depth data in
the NMEA0183 standard format. You need to connect the specified signal
line to the NMEA connector on the rear panel to receive the water depth
data.
•To display the speed through the water (STW), it is necessary to receive the
speed through the water data in the NMEA0183 standard format. You
need to connect the specified signal line to the NMEA connector on the
rear panel to receive the water speed data.
OFF COURSE SHALLOW
SOFT
KEY
SOFT
KEY
SOFT
KEY
SOFT
KEY
N 42° 34.255'COG 92.5° DGPS
W122° 19.487'SOG 25.5KTS
WPT
001 ABCDEFGH
ETA
21 OCT 10:54AM
RNG
NM
15.7
HDG
°
T
82
.
5
SOG
KTS
25
.
5
COG
°
T
92
.
5
STW
KTS
20
.
3
BRG
°
T
72
.
5
DPT
FT
69
.
3
0.02
XTE
VESSEL POSITION
21 OCT 8:28AM
N 4 2 ° 5 1 . 8 1 8 '
W 8 7 ° 5 1 . 1 3 6 '