Section 2 Installation
32
Figure 2-7 Belt Fitting Method
Belt fitting method
ATTENTION
• Do not fasten the junction of connectors with the
fitting belt.
It may cause connector damage.
• Do not coil the fitting belt around the aluminum base.
The aluminum base will be scratched with the belt
and may cause corrosion.
GPS/DGPS
Sensor
Do not coil the fitting
belt around the
aluminum base.
Cable
20mm
(Sensor case bottom
to Mast top)
Plastic
Mounting
Unit
Fitting belt
Mast
(ø26- ø50)
1. Loosen the fitting belt screw
with a screwdriver and
remove the clamp.
Clamp
Minus screw driver
2. Coil the fitting belt around
the mast as shown below.
3. Tighten the clamp screw
with a screwdriver.
To Next Page
Loading...
