Juniper EX9214

CAUTION: Do not let ber-opc cable hang free from the connector. Do not allow
fastened loops of cable to dangle, which stresses the cable at the fastening point.
CAUTION: Avoid bending ber-opc cable beyond its minimum bend radius. An arc
smaller than a few inches in diameter can damage the cable and cause problems that
are dicult to diagnose.
Figure 87: Install a Transceiver
1—
Ejector lever
Maintaining Alarm Relay Wire
IN THIS SECTION
Disconnecng the Alarm Relay Wires from the Cra Interface in an EX9200 Switch | 272
Connecng the Alarm Relay Wires to the Cra Interface in an EX9200 Switch | 272
271