Juniper EX9214 Hardware Guide

1—
Ejector lever
4—
LEDs for the ports
2—
Line card LED
5—
40-Gigabit Ethernet ports
3—
MIC LED
You can use the show version command to see the version of Junos OS for EX Series switches loaded on
the switch.
Line Card Components
The EX9200-4QS line card has:
• Four 40-Gigabit Ethernet ports, each of which can house QSFP+ transceivers.
• Four dust covers preinstalled in the ports.
• Line card LED—An LED labeled OK/FAIL, which indicates the status of the line card. See Line Card
LED in an EX9200 Switch .
• MIC LED—An LED labeled OK/FAIL on each MIC, which indicates the status of the MIC. See
Modular Interface Card LED in an EX9200 Switch .
• LEDs for the ports—One LED on each port, the Link/Acvity LED, which indicates the link status and
acvity on the port. See Network Port LEDs on Line Cards in an EX9200 Switch .
EX9200-6QS Line Card
IN THIS SECTION
Line Card Models | 88
Line Card Components | 88
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet interfaces in a
single assembly. Line cards are eld-replaceable units (FRUs) that you can install in the line card slots on
the front of the switch chassis. Line cards are hot-insertable and hot-removable: You can remove and
replace them without powering o the switch or disrupng switch funcons.
87

Juniper EX9214 Specifications

General

Brand	Juniper
Model	EX9214
Category	Switch
Language	English