Juniper EX9214

SEE ALSO
Dashboard for EX Series Switches
Chassis Component Alarm Condions on EX9200 Switches
IN THIS SECTION
Backup Roung Engine Alarms | 299
This topic describes the chassis component alarm
condions on EX9200 switches.
Table 61 on page 293 lists the alarms that the chassis components can generate on EX9200 Switches.
Table 61: Chassis Component Alarm Condions on EX9200 Switches
Chassis
Component
Alarm Condion Alarm
Severity
Remedy
Air lters Change air lter. Minor
(yellow)
Replace the air lter.
Alternave
media
The switch boots from an
alternate boot device, the hard
disk. The CompactFlash card is
typically the primary boot
device. The Roung Engine
boots from the hard disk when
the primary boot device fails.
Minor
(yellow)
Open a support case using the Case
Manager link at hps://www.juniper.net/
support/ or call 1-888-314-5822 (toll free,
US & Canada) or 1-408-745-9500 (from
outside the United States).
Cra interface The cra interface has failed. Major (red) Replace the failed cra interface.
Line Cards A line card is oine. Minor
(yellow)
Check the line card. Remove and reinstall
the line card. If this fails, replace the failed
card.
293