Juniper EX9214

The ports labeled 0/0 through 0/9 form pic 0 and the ports labeled 1/0 through 1/9 form pic 1. The
ports labeled 2/0 through 2/9 form pic 2 and the ports labeled 3/0 through 3/9 form pic 3.
EX9200-40F-M Line Card
IN THIS SECTION
Line Card Models | 105
Line Card Components | 106
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet interfaces in a
single assembly. Line cards are eld-replaceable units (FRUs) that you can install in the line card slots on
the front of the switch chassis. Line cards are hot-insertable and hot-removable: You can remove and
replace them without powering o the switch or disrupng switch funcons.
Line Card Models
Table 37 on page 105 shows the model number, descripon of the line card model, and the Junos OS
release in which the line card was rst supported.
Table 37: EX9200-40F-M Line Card
Model Descripon Junos OS
Release
Required
EX9200-40F-M A line card with 40 1-Gigabit Ethernet ports with Media Access Control
Security (MACsec) capability, each of which can house 1-gigabit small form-
factor pluggable (SFP) transceivers. The EX9200-40F-M line card supports
802.1AE IEEE MAC Security standard (also known as MACsec) with
AES-128 bit encrypon, providing support for link-layer data condenality,
data integrity, and data origin authencaon. You must apply a single license
—EX9200-SFL—to enable MACsec.
14.2R1 or later
105